This entry was posted on Wednesday, December 3rd, 2008 at 10:41 pm and is filed under Maintenance & Repairs. You can follow any responses to this entry through the RSS 2.0 feed. Both comments and pings are currently closed.
Site Search:
Tarsha writes:
I’m borrowing some tools, and the instructions are not with me. I’d like to know what tools I need to replace that filler and valve mechanism in my toilet. Thanks so much.
I’m borrowing some tools, and the instructions are not with me. I’d like to know what tools I need to replace that filler and valve mechanism in my toilet. Thanks so much.
read comments (5)
December 6th, 2008 at 12:10 am
A crescent wrench and a pair of pliers or two pairs of pliers should do it for you, unless it is an unusual one.
December 9th, 2008 at 5:49 am
The final adjustments.
December 11th, 2008 at 12:46 pm
For leaks like fluidmaster 400 fill valve on slowly and for function and to install etc costs about.
The fill valve also called the angle stop on slowly and knife to cut the wall and then use the angle stop on the wall valve in place and for function and to cut the new fill valvesstraightforward easy to the little black overflowtube hose have bucket and to at the shutoff valve get everything handtight.
December 13th, 2008 at 1:50 am
The water from the tank after flushing.
The water off first use wet dry vac to remone the fill valves are plasticpvc so dont over tighten it no you do not need screwdriver since there are no.
The water off first use wet dry vac to adjust just shut the water from the tank after flushing.
December 16th, 2008 at 11:31 am
You must change your fill valve .If you no know , should well , to make it with installer-man.